SICK CLV490 Instrukcje Operacyjne Pobierz pdf (Strona 49)

Operating Instructions Chapter 5

CLV 490 Bar Code Scanner

8 008 796/0000/25-06-2002

5-3

Electrical installation

5.2.3 Connections/cables for the AMV/S Connection Module

The AMV/S Connection Module is suitable for connecting the CLV to peripherals (distribution

function) and the power supply. The module can be used to establish a connection to the

host (point-to-point) or integrate the device in a SICK network or daisy-chain configuration

(pass-through or master/slave configuration). The module is available in several variants

(see

Table 5-1, Page 5-1).

Fig. 5-1

shows the connection principle of the AMV/S 60 for one CLV.

Connecting the CLV to the AMV/S

Two cables no. 2 020 302 are required to connect the CLV to the AMV/S. Alternatively, the

device can be connected via the external parameter memory no. 2 020 307.

See

Chapter 5.2.5 Connections/cables for the external parameter memory (connection to

AMV/S or BMV 10/BMS 20), Page 5-4.

a) CLV without heater:

Connection modules: AMV/S 60 and AMV 30-071.

The cables no. 2 020 302 can be extended to 10 m (terminal interface: RS 232!).

b) CLV with heater:

Connection modules: AMV 100 and AMV 200.

The cables no. 2 020 302 must not

be extended!

If longer cables are required, the entire power supply system (Pin 1/Pin 5) must be

connected with a wire cross-section of at least 0.75 mm

with a maximum length of 10 m.

Recommendation Use the cable no. 2 021 298 (with two connector covers, length 3 m).

The procedures for connecting and configuring the AMV/S Connection Modules are

described in the following documentation:

•

Operating Instructions for the "

AMV/S 60 Connection Module"

(no. 8 008 296)

•

Operating Instructions for the "

AMV 30-071 Connection Module"

(no. 8 008 648)

•

Operating Instructions for the "

AMV 100/200 Connection Module"

(no. 8 008 879)

Fig. 5-1: Block diagram: Connection of the CLV to the AMV/S 60 connection module

Photoelectric

switch

Reading pulse

Photoelectric

switch

Focal position

Trigger One-Shot

Conveyor increment

CLV 490

AMV/AMS 60

connection module

HOST/PLC

PLC

18 ... 30 V DC (AMV 60-011)

230 V AC 50 Hz (AMS 60-013)

115 V AC 50/60 Hz (AMS 60-012)

– – Cable if required (if necessary)

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 213 214

Komentarze do niniejszej Instrukcji

Brak uwag

SICK CLV490 Instrukcje Operacyjne Strona 49

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czytniki kodów kreskowych SICK CLV490